sensor and modules

MCP2515 CAN Module TJA1050 Receiver SPI 51 Single Chip Program Routine Arduino

Availability: 

In stock

 
  1. Support CAN V2.0B technical standard, communication rate 1Mb / S.
  2. Module 5V DC power supply, SPI interface protocol control
  3. 0 to 8 bytes long data field.
  4. 8MHZ crystal oscillator
  5. 120Ω terminal resistance
  6. Use High-speed CAN transceiver TJA1050
  7. Impedance matching, guaranteed drive capability, long-distance data transmission, prevent signal radiation
  8. The working current: typical 5mA, standby current 1 microamp. Except for the power indicator.

₹ 75.00 (Incl. GST)

 

This is the MCP2515 CAN TJA1050 SPI Receiver Module 51 Single Chip Program Arduino routine with this module, with this module you will find easy to control any CAN Bus device via SPI interface with your MCU like Arduino UNO and compatible with Arduino based microcontroller projects. Pin definitions Input pin VCC 5V GND power ground pin CS SPI SLAVE select pin (active pin) SO SPI master output slave input pin SCLK SPI clock pin INT MCP2515 interrupt pin Interface J1 120R resistor terminal selection Block output J2 CANH, CANL KF301-2P Output pins J3 CANH, CANL

Scroll to Top